QuoteDisplay MoreOriginally posted by speedyisfast
HI this is supported yet by arduino.
in the config set type to momo and use the prefix same as the ws2801.
For info see this page:
http://www.tweaking4all.com/ho…t-openelec-ws2811-ws2812/
Works the same for EnigmaLight
Grub Speedy
Good to know. Thanks for the info. I'll try.
QuoteOriginally posted by holymoly
i have tested again with my WS2812B.
You must take the prefix from his site, then the lights go on.
But some LEDs are flicker sometimes.
My scetch is much smaller and stable.
holymoly, could you please share your scetch as well?
