mumudvb - OE2.5 - armhf/mipsel

[20:45 root@dm900 MuMuDVB] > mumudvb --help
MuMuDVB is a program who can redistribute stream from DVB on a network, in multicast or in http unicast.
It's main feature is to take a whole transponder and put each channel on a different multicast IP.


Usage: mumudvb [options] 
-c, --config : Config file
-s, --signal : Display signal power
-t, --traffic : Display channels traffic
-l, --list-cards : List the DVB cards and exit
--card       : The DVB card to use (overrided by the configuration file)
--server_id  : The server id (for autoconfiguration, overrided by the configuration file)
-d, --debug  : Don't deamonize
-v           : More verbose
-q           : Less verbose
--dumpfile   : Debug option : Dump the stream into the specified file
-h, --help   : Help


MuMuDVB Version 2.1.0_20180602_mumudvb2
 --- Build information ---
Built with CAM support.
Built with SCAM support.
Built with ATSC support.
Built with ATSC long channel names support.
Built with support for DVB API Version 5.10.
Built with support for DVB-T2.
---------
Originally based on dvbstream 0.6 by (C) Dave Chapman 2001-2004
Released under the GPL.
Latest version available from http://mumudvb.net/
Project from the cr@ns (http://www.crans.org)
by Brice DUBOST (mumudvb@braice.net)

[11:52 root@dm900 dvbtune-0.5] > ./dvbtune
Usage: dvbtune [OPTIONS]


Standard options:


-f freq     absolute Frequency (DVB-S in Hz or DVB-T in Hz)
            or L-band Frequency (DVB-S in Hz or DVB-T in Hz)
-p [H,V]    Polarity (DVB-S only)
-s N        Symbol rate (DVB-S or DVB-C)
-v vpid     Decode video PID (full cards only)
-a apid     Decode audio PID (full cards only)
-t ttpid    Decode teletext PID (full cards only)
-pnr N      Tune to Program Number (aka service) N


-i          Dump SI information as XML


Advanced tuning options:


-c [0-3]    Use DVB card #[0-3]
-tone [0|1] 0=22kHz off, 1=22kHz on
-I [0|1|2]  0=Spectrum Inversion off, 1=Spectrum Inversion on, 2=auto
-D [0-4]    DiSEqC command (0=none)


-qam X      DVB-T modulation - 16, 32, 64 (default), 128 or 256
-gi N       DVB-T guard interval 1_N (N=32 (default), 16, 8 or 4)
-cr N       DVB-T code rate. N=AUTO, 1_2, 2_3 (default), 3_4, 5_6, 7_8
-bw N       DVB-T bandwidth (Mhz) - N=6, 7 or 8 (default)
-tm N       DVB-T transmission mode - N=2 (default) or 8
-x          Attempt to auto-find other transponders (experimental - DVB-S only)
-m          Monitor the reception quality
-n dpid     Add network interface and receive MPE on PID dpid