HI
I received today a new HD 900 UHD satellite receiver from HM-SAT via Amazon.
Dreambox DM900 UHD 4K 1xDVB-S2 Dual Tuner E2 Linux PVR Receiver
but when i install it, it has no signal for all sats.
it marked tune failed “echec accord” in french always (no signal).
However It detects the two tuners DVB-S2.
When I replace it with another mine old receiver HD800 this last works fine! That is to say that my sat installation is good.
what's the matter with it my HD 900 ?
help please.
new HD 900 Tune failed problem
-
-
What are your settings for the tuner configuration? Did you check them with your satellite setup and the settings on the 800?
-
hi
My tuner configuration is for collective réception for 3 sats, as below:
Tuner A
Simple
diseqc A/B/C/D
A : 19,2 E ASTRA
B : 13 E HOTBIRD
C : 7 W NILESAT
D : not configuredTuner B: not configured
Yès when i tested with my old HD800 it works perectly !!
Thank you
-
Tuner B installiert werden müssen
-
Auf welcher coniguration ?
dies ist das gleiche wie das von dem Tuner A?
-
Versuchen Tuner B
-
wie es funktioniert nicht
ist, dass die zwei Tuner zwingend branchs sind?
-
At Last I will resend it to Hm-sat.