Hallo,
I have a Dm7000S with boot problem. He display only Dream Multimedia logo. On the HyperTerminal I have only “Dreambox DM7000” and nothing else.
I try with jtag and Processors and memory are ok, I write and was ok…
Any ideas?
MFG
Hallo,
I have a Dm7000S with boot problem. He display only Dream Multimedia logo. On the HyperTerminal I have only “Dreambox DM7000” and nothing else.
I try with jtag and Processors and memory are ok, I write and was ok…
Any ideas?
MFG
Bootlog
Boot log with what program?
If I use HyperTerminal...I have only: Dreambox DM7000
Nothing else.
Hi,
did you try a flash erase? Your settings will be gone.
ciao
Mainboard broken and must be repaired
@Trial...How? If I can't conect with serial?
@bolvan...it's possibile to give me more infos?
On the motherboard are many components...which one is defective?
processor, flash, serial port...???
Hi,
flash reset is done my pressing the key up or down (don´t know which) direct at the box when you switch it on. You should see a message "flash erase" on the display and then the initial settings are active again if you are lucky.
ciao
Hallo,
I try this now...on the key up, the light is dim(low light) after logo Dm.
With key up...same.
MFG
usually there is nothing broken, you have to flash the boot-loader, before flashing a new image ..
maybe someone here can explain it how to do, as i have no idea about doing this.
YES…Finally I manage to connect DreamUP to box. Some time the box don’t display nothing on LCD and I find less voltage on the pin no.1 on IC6001 (2,5V) must be 3,3V, checking input on pin no.8, was less than 5V. I change the C6008 and the box boot ok with Dm logo.
But I can’t erase the flash and I can’t write a new flash. Pls. see the picture.
[Blockierte Grafik: http://d.imagehost.org/t/0850/Capture.jpg] [Blockierte Grafik: http://d.imagehost.org/t/0353/Capture2.jpg] [Blockierte Grafik: http://d.imagehost.org/t/0576/Capture3.jpg]
Now I have Bootlog with some errors.
I think the 28F640 is defective…
I think the 28F640 ok
I think the IC6001 LM78L05 Pin1 should be 5V
Please check voltages on the motherboard
Front processor Atmega8 IC2 check
You have right...I make a mistake, IC6001 pin no.1 it's 4,87V, same on pin 4 and 6 of ATmega.
I believe this 28F640 is defective because can't erase...
I found a cheaper model JS28F640J3D75.
The IC6002 when starts, after box boot? On the pin no.4 I have 22,1V and on the pin no.5 0V. The control pin no.2 it's high...2,4V
Please check voltages on the motherboard
send me and I fix your dreambox 7000
then you can see the 28F640 ok:))))))))))
ZitatOriginal von bolvan
Please check voltages on the motherboard
Please give me some indication’s...where to check? Why this flash don’t erase?
I will send you a beer…not the box!, if you can tell me how to fix it. It’s my pleasure to repair this old but gold box!!!
Any "Experte"...???
zur Zeit sind 29 Mitglieder (davon 2 unsichtbar) und 1.971 Gäste online - Rekord: 5.681 Benutzer ()