flash erase 7025

  • Hi, I have problems with my 7025 freezing during Boot. I have Gemini 2 image installed and boot halts showing gemini logo. Network is OK.


    I have tried flashing new image with the lates dream up, but when powering up DB, dream up still displays "power up ypur DB"
    Flash wizard pro connects nicely to the dreambox..?? What am I missing?


    I also tried with nul-moddem cable with the same results.. (No connection).. this is the same cable I used to install the Gemini image..


    Please help..!!

  • Hi!


    Have you tried to flash your 7025 with the web interface?


    switch off the box and hold the down key on the front of the box


    pressed when you switch it on.........


    now you see a message in the display.......


    if you can see an ip .........192.168.2.21 and the word stop you


    can connect to the box with a web browser........


    now type this ip in your browser an a webscreen from the 7025 will appear......


    go on flash an the to the directory where you have the image to install



    hope you understand!


    Regards


    Guano

  • I think this is hardware error


    Try to flash it using the web interface if it fails so u have a hardware error as it is not responding to network , dreamup, nor nullmodem cable.


    Plz post your result



    Greetings

  • You could try to connect the box with RJ45 AND serial
    then launch dreamup, enter the ip address of your dreambox in Dreamup
    connect with dreamup button
    then switch on your dream, dreamup should display the ident of your dreambox
    good luck

    DM8000, DM800SE, DM800, DM500HD

    Einmal editiert, zuletzt von mimi74 ()

  • Thank you all for your help and good hints!


    I did not know that a web browser was present in the 7025.
    A new image is flashed and I am ready to configure the DB again..


    Thank you!

  • webbrowser works fine for me ;). Have no serial cable. But I was trieing or it works with dreamup. So dreamup doesn't work for me (by network).


    greets Xetec